| Brand | WESCO |
| Tank volume | 800 Millilitres |
| Colour | Blue |
| Style | Painting |
| Power source | Corded Electric |
About this item
- 3 Nozzles & 3 Spray Modes: horizontal, vertical and circular modes and 3 nozzles of 1.5/1.8/2.0mm covers various works indoor and outdoor; and you are able to finish painting effectively and efficiently
- Easy Cleaning and Detachable Design: Paint container，gun head, air cap, nozzle, cap nut, suction pipe are designed detachable, so you can remove the parts and clean them conveniently
- Viscosity Measurement: With a viscosity cup to measure the DIN value of your paint, you are able to spray the paint evenly and efficiently
- Adjustable Knob & 2 Meter Cable: Fully adjustable pressure valve knob, the maximum flow rate can reach 800ml/min. 800ML paint container and 2 meter extra-long cord allows you carry it steadily and easily. Also you can have a better control of spraying
Product Description
Various Applications and Easy Operation:
1. Garden furnitures, decking, sheds, patio remodeling, panels and fences
With this WESCO paint sprayer, you save a lot time and energy in paiting and decorating
2. Keep your spray gun level and parallel to the surface at all times. Keep the nozzle 5~15cm from the surface and spray evenly from side to side or up
and down, use smooth and even strokes.
- Make sure that you have masked the areas that should not be sprayed by a good quality masking tape.
- The intended area to be sprayed should be pretreated to be smooth and clean, free from dust.
- Before operating, aim the paint sprayer at a piece of scrap material and start spraying to find the best pattern and flow rate.
ADJUSTING THE RATE OF FLOW
The sprayed capacity can be adjusted by using the flow rate adjusting knob. Adjust the adjusting knob until the best spray pattern is reached.
- Turn the adjusting knob clockwise (+) to inc rease the flow rate and turn it counterclockwise (-) to decrease the flow rate.
- A poor spray pattern will concentrate the paint in the centre of the spray and give a blotchy finish.
- A good spray pattern will give even distribution of paint throughout the pattern.
To determine the correct viscosity:
1) Stir well the paint before the starting to measure. Check the DIN list, if the print is suit your requirement, go ahead. If the seconds lead you to have a more thin print, you can follow below step.
2) Fill the viscosity cup to the brim with paint.
3) Measure the time in seconds of liquid dripping from the cup into the can until the cup is empty. The measured time is called run-DIN-seconds (DIN-s).
4) Verify the suit ratio,when you find the suitable ratio, you can pull them in the sprayer container.
This WESCO paint sprayer has been used, shown through some residual paint left over in the paint pot, as well as a few splashes on the items body. It has been tested however and is working perfectly.
Reviews
There are no reviews yet.